Base of case - DFM. 产品信息

1.

base of case-DFM
版本Version
A0
作成 Prepared by
确认Checked by
核准 Approved by
日期 Date
2024-9-21

2.

产品信息Part Over review
产品编号 P/N
back cover+Front
cover
材料 Material
ADC12
缩水率 Shrinkage
1.005
表面处理Surface treatment
重量 Weight (Kg)
尺寸 Dimension( mm)
环氧基喷粉RAL3020
标红位置
490g
132.5*108.7*72.8m
m
模穴数 Cavity
1*1
行位数量 Slider Qty
2
机台吨位 Machine tonnage
280T
模具寿命 Tooling lifetime
50~60K
模具制造周期 Tooling L/T
35 days
Product Picture
base of case

3.

模具信息 Tooling Information
•Draft analysis
Feedback
客户回馈
标识外侧壁加胶拔模角度1.5° 分型线打磨The outer
side wall of the logo is glued and the draft angle is 1.5°,
and the parting line is polished
What does it mean:
“The outer side wall
of the logo is glued” ?
Do you have a photo
as an example?

4.

模具信息 Tooling Information
•Ejection system
红色位置为顶针分布,顶针下沉0.2mm。请确认3D是否会影响装配
The red position is the distribution of the thimble, and the thimble
sinks 0.2mm.
want to know if 3D will affect the assembly?
Feedback
客户回馈
The height of the
racks must
correspond to the
drawing.

5.

尺寸分析 Dimensional analysis
图示 标识尺寸垂直度放松至0.15mm以内。
veticality to be within 0.15mm
Feedback
客户回馈
The verticality must
correspond to the
drawing. Use
machining.

6.

尺寸分析 Dimensional analysis
图示外圆加工后会有变形 公差无法管控在H5以内。
公差管控为 +0/-0.1 The figure shows that there will be
deformation after cylindrical machining, and the tolerance cannot
be controlled within H5.
The tolerance control is +0/-0.1
Feedback
客户回馈
The tolerance must
correspond to the
drawing. Use
machining.

7.

谢谢
The end. Thank you!