Chip conveyor belt problem feedback and solutions （TONEX）

1.

1. Our pipe diameter is 0.5 mm larger
The reason is as follows: Since the Chinese Pipe standard is only 25mm, if you use your 24.5mm pipe, the cost will increase
greatly (because all pipes need to be specially customized). So in the conference room, our engineer proposed to you to
use 25mm pipe. At that time, our engineer got your reply: As long as it does not affect the normal use of the chip conveyor
belt on the machine, we can change some dimensions in a small range.
2. Feedback from engineers of belt
Our engineers reported that our Pipe (25mm) cannot be compatible with your old chip conveyor belt, and your Pipe
(24.5mm) cannot be compatible with our chip conveyor belt.
The reasons are as follows

2.

Because the pipes are different, the holes we
make are 1mm larger than yours.
This results in that when the new chip
conveyor belt is connected to the old chip
conveyor belt, the new chip conveyor belt will
squeeze the old chip conveyor belt, so that
they cannot be assembled with each other.

3.

We have two solutions
1. Use a whole chip conveyor belt produced by us, do not splice it with the old one
2. Cut the new chip conveyor belt and the old chip conveyor belt,Then weld the new chip conveyor belt and
the old chip conveyor belt together and it can be used normally.